Abstract
The models of Rubber Roller Husker Vibrating Feeder and rice particle are obtained through the discrete element analysis software EDEM. Simulate the movement of material flow in the vibrating feeder by setting up the corresponding parameters. The average speed of single particle is 0.22 m/s roughly under the theoretical parameters, and the average velocity of material flow is around 0.24 m/s. The trajectory is achieved and the feeding uniformity is discussed. In order to verify the feasibility of the simulation results, adopt vibration meter GM63B to measure the actual velocity of material flow under the different amplitude in the experimental vibrating feeder, which can provide reference for analysis of material flow in the new vibrating feeder design.
Publication Date
5-28-2016
First Page
91
Last Page
93
DOI
10.13652/j.issn.1003-5788.2016.05.021
Recommended Citation
Lele, JIA and Jinglan, RUAN
(2016)
"Discrete element simulation and experiment research of material flow in rubber roller husker vibrating feeder,"
Food and Machinery: Vol. 32:
Iss.
5, Article 21.
DOI: 10.13652/j.issn.1003-5788.2016.05.021
Available at:
https://www.ifoodmm.cn/journal/vol32/iss5/21
References
[1] 刘凯欣, 高凌天. 离散元法研究的评述[J]. 力学进展, 2003(4): 483-490.
[2] 徐泳, 孙其诚, 张凌, 等. 颗粒离散元法研究进展[J]. 力学进展, 2003(2): 251-260.
[3] 伍毅, 阮竞兰, 伍维维, 等. 胶辊砻谷机工作参数配置优化研究[J]. 食品与机械, 2013, 29(3): 182-186.
[4] 姜鹏. 基于离散元法的碾米机三维仿真分析[D]. 哈尔滨: 东北农业大学, 2013: 38-40.
[5] 王国强, 郝万军. 离散单元法及其在EDEM上的实践[M]. 西安: 西北工业大学出版社, 2010: 16-25.
[6] 于亚军. 基于三维离散元法的玉米脱粒过程分析方法研究[D]. 长春: 吉林大学, 2013: 105-111.
[7] Zhang Rui, Els D N J. Calibration of discrete element parameters and the modeling of silo discharge and bucket filling[J]. Computers and Electronics in Agriculture, 2009, 65: 198-212.
[8] 赵啦啦. 振动筛分过程的三维离散元法模拟研究[D]. 徐州: 中国矿业大学, 2010: 77-119.